Furnace not working in a Minnesota cold snap? Check these 7 things first
By Atass Comfort · Published

Short answer: If your furnace stops during a cold snap, check the thermostat mode and batteries, the furnace power switch and breaker, the filter, the furnace door, the outdoor intake and exhaust pipes for snow or frost, and the condensate drain. If none of that brings the heat back, or you smell gas, call for repair.
1. Is the thermostat actually asking for heat?
Start where the request starts. Make sure the thermostat is set to Heat, not Cool or Off, and that the set temperature is a few degrees above the room. A blank screen usually means dead batteries. (Every house has one person who swears they didn’t touch it. They touched it.)
Smart thermostats can also lose Wi-Fi or run a schedule nobody remembers setting. Bump the temperature up manually and give it two minutes.
2. Does the furnace have power?
Most furnaces have a switch on or near the unit that looks exactly like a light switch. It gets flipped off by accident more often than you’d think, usually by someone looking for the basement light. Check that switch, then check the breaker panel for a tripped furnace breaker.
3. When did the filter last get changed?
A clogged filter chokes the airflow, the furnace overheats, and a safety switch shuts the burners off. Pull the filter. If you can’t see light through it, replace it and reset the system by turning the power off for a minute and back on.
4. Is the furnace door on properly?
Furnaces have a door safety switch. If the front panel is loose or sitting crooked after a filter change, the furnace won’t run. Seat the panel firmly until it clicks.
5. Are the outdoor vent pipes blocked by snow or frost?
High-efficiency furnaces vent through two white PVC pipes on the side of the house. Drifting snow or a frost cap can block them, and the furnace shuts down to protect you. This is the most Minnesota item on the list. Clear snow and frost from around both pipes carefully, by hand, without damaging them.
6. Is the condensate drain frozen or full?
High-efficiency furnaces make water. If the drain line or condensate pump is frozen or full, a float switch stops the furnace. Look for a small pump near the furnace with standing water, or a drain line running somewhere cold.
7. What is the status light saying?
Most modern furnaces have a small window with a blinking LED and a code chart printed inside the door. Count the blinks and write the code down. It won’t fix anything by itself, but it tells the technician where to start, which can save time on the visit.
When to stop checking and call for furnace repair
- You smell gas: leave the house and call your gas utility from outside first.
- The furnace starts, runs briefly and shuts off again and again.
- You hear banging, grinding or screeching from the unit.
- The breaker trips again after you reset it.
- None of the checks above brought the heat back.
Atass Comfort returns every call within two hours during business hours, offers 24-hour emergency service, and keeps common furnace parts in stock. Call (763) 458-5314.
Quick answers
Why does my furnace keep shutting off in extreme cold?
The most common causes in extreme cold are blocked outdoor vent pipes, a frozen condensate drain and a dirty filter. Each one trips a safety switch that turns the burners off.
Is it safe to reset my furnace myself?
Turning the power off and back on once is safe. If the furnace keeps shutting down, stop resetting it and call for repair, because repeated resets can hide a real fault.
How long can a house go without heat in a Minnesota winter?
It depends on insulation and outdoor temperature, but pipes can be at risk within hours in sub-zero weather. Treat no heat in a cold snap as an emergency.
More on this: our heating service, or ask us for a quote.




